Results 1 to 9 of 9
Threaded View
-
12-11-2014, 06:56 AM #9
- Join Date
- Nov 2014
- Posts
- 9
Haha funny that you should comment I was just thinking today that I should follow up with an update.
So I did fix the warps in my layer but further reducing my z tip and turned down my layer hights. I can now print fairly accurate and clean prints but now faced with a new problem with the topside of my prints. Rather than having a smooth finish on the top its practically open so you can see the infill of the print. I have tried to turn up the top fill amount but still no luck. Can post some detailed picks tomorrow.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help