Results 1 to 10 of 46
Threaded View
-
12-09-2014, 05:06 PM #39
- Join Date
- Nov 2014
- Location
- Kentucky, US
- Posts
- 70
One of the main advantages to locating the MOSFET PCB on or near the heater PCB is that you could use the light gauge OEM wires for a very short run from the heater to your new PCB. This would avoid the need to desolder the OEM leads, and replace them with heavier gauge leads.
BTW, I am very jealous about the pick and place machine
Jim
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion