Results 1 to 10 of 13
Thread: Levelling the plastic bed arms?
Threaded View
-
11-22-2014, 01:39 AM #8
Have you measured from the bottom of the cabinet up to one side of the black arms, and then the same on the other side? because its really hard to tell from the photos as Mjo said, then to me the picture is showing a very warped L shape on the bed but its hard from the photo angle.
Hex3D - 3D Printing and Design http://www.hex3d.com
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion