Results 1 to 10 of 14
Threaded View
-
11-16-2014, 10:15 AM #6
Good work figuring out it is something else causing the Z to not move!!! I'm wondering if you are taking too much power from your power supply when you have the Z-Probe engaged and that is keeping the Z motors from moving? But here is something that doesn't make sense to me: How can you be probing the bed if the Z axis won't move when the Z-Endpoint is engaged? As soon as it touches the bed, it will freeze and not go up any more? Is that correct?
Any way... I'm glad you figured out that extra information because for sure that is going to be helpful in getting you going.
OH! And there isn't a configuration option to keep the Z axis from moving while the endpoint is triggered. But I could imagine a situation where you have the wrong values for your Z offset and if you have #define DISABLE_MIN_ENDSTOPS commented out... It might not want to move after it sets the Zero point.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion