Dual nozzle alignment jig my nozzles are out of alignment.

[Geoff]

I would have to believe that flashforge must have an alignment jig for setting the nozzle heights to be identical. I know I could make sure my bed is level and do the same thing.

My heads are out of alignment by about .06mm from each other. I just want to get them set.

But is there a metal jig available? I know thingiverse has some prints, but I would really like a metal one. Can one be had anywhere?

whats the best way to do this? You can't really use a caliper, as the back side of the nozzle gets in the way.

Help.

thanks

m

Hi, you can adjust the height by removing the fans (old flashforge the hexnuts are on the front of the metal carriage, new flashforge they are on the back and harder to get to.

Just a note.. the nozzles are not meant to be exactly the same no, 0.6 is a little too much but really, if they are 0.1 to 0.2mm in difference you can still print ok and you don't get the other head dragging across your prints.