Results 1 to 10 of 11
Threaded View
-
11-09-2014, 04:02 PM #6
That is my issue!!!
If I am printing little parts and raftless... I actually push the whole platform up at the front while its printing that first layer (just a smidgen with my finger ) because no matter how I freakin level it, the back ends up being a bit higher than the front, so I literally push the platform up and make sure the nozzle is really close for that first layer. After getting a set of spirit level guide things for 3d printers (like you stick them all over the thing) I found my hotbed was not an 'L' shape it was more a droopy L.Hex3D - 3D Printing and Design http://www.hex3d.com
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion