Results 1 to 7 of 7
Thread: i3v 8" Extruder Stepper Issues
Threaded View
-
11-01-2014, 11:57 AM #6
Just to clarify, everything worked OK up to the firmware update, and the issue started with the update and not a while later? And NOTHING else was done or has been changed? No adjustments were made, the same filament is being used, the same temperature settings are being used, etc.? I can think of a few mechanical things that could be causing problems, but they'd have no tie to the firmware update.
Printed Model of Motor Cooling Fan...
06-09-2024, 02:07 PM in General 3D Printing Discussion