Results 1 to 10 of 11
Thread: Reprap printers for beginners...
Threaded View
-
12-06-2013, 05:09 PM #3
I think this is basically good advice. Learn what you are doing, learn what YOU want from a printer, just get the feel for the entire thing. It might be best to start with one of the "CHEAP" 3D printers, I do not care for the laser cut, wood printers, or other "cheap" printers, however, they are a good way to figure out whether or not you want to be messing with this stuff, with out spending a small fortune. Plus steppers, and other parts might be able to be used on a build when and if you decide you want to build a custom printer.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion