Close



Results 1 to 5 of 5
  1. #1
    Technician
    Join Date
    Oct 2013
    Posts
    84

    Print is not fitting on the printbed

    Hello,

    I use ABS on my Up2 plus printer.
    I have a heated printbed also, but the print loses grip wenn its a bigger object. So, the print will be a disaster.

    Can anyone help me with some solution?

    Thanks!

    Gr. René

  2. #2
    Technologist MeoWorks's Avatar
    Join Date
    Oct 2013
    Location
    Sacramento, CA
    Posts
    173
    What temperature is your print bed? Please provide as much info about your setup as possible so we can better help you

  3. #3
    Technician
    Join Date
    Oct 2013
    Posts
    84
    Hey, temp from my printbed is around 100 / 115 Celsius. But its a bit better no, cause I put the nozzle a bit more to the print bed. Hopely it will be good in a few times.

  4. #4
    Student PrinterNinja's Avatar
    Join Date
    Oct 2013
    Location
    Wellington, Florida, USA
    Posts
    24
    How did it go Rene? I have an Afinia, which is the same printer as yours. You need to keep the nozzle close to the bed and the bed has to be very, very level. Watch the first layer carefully...if the plastic is not getting pushed into the bed it probably won't stick well. You might as well stop printing at that point and try again.

  5. #5
    Technician
    Join Date
    Oct 2013
    Posts
    84
    Hey,

    sorry for my late post.
    I finally had the right ways. Now its only a bit noisy, (like a peep), but thats okay for me.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •