Hi Roxy Thanks for the reply
I don't think its a slicer problem because prints made from the Makerbot supplied SD card print with an error in the same spot eg: front left side
I am using the latest version of Makerware .
Here is a witches hat just printed off the SD , as you can see there is a error down the front left side , although not as bad as the other model print .
If it is a slicer problem then its a problem every makerware user would have because its showing on presliced models on the SD card supplied by Makerbot and sliced models sliced with the latest version of Makerwave ,

So I think it must be something wrong with my Makerbot since it arrived broken and I fixed it , well almost fixed it lol

WP_20141006_003.jpg