Results 21 to 30 of 72
-
08-15-2014, 01:09 AM #21
- Join Date
- Aug 2014
- Posts
- 6
-
08-15-2014, 01:40 AM #22
I'm just causing trouble. Its a smart a$$ comment about what that corporate chain is doing with intellectual property. Of course there are two sides to the story... But this side makes the most sense to me:
http://traverseda.wordpress.com/2014...munity-design/
-
08-15-2014, 04:01 AM #23
-
08-15-2014, 06:04 AM #24
this direct drive bowden extruder.
Given that the ff isn't a bowden setup - why would I want it ?
-
08-15-2014, 09:45 PM #25
It's just an overly used term for an extruder that is a direct input, sorry I should have said "chinese clone plastic injection molded direct drive extruder"
there is many 'Bowden' setups that will work with the flashforge, ill find one on thingiverse, essentially you just want a block that holds the bearing and has a hole, it's about as basic as they get I reckon. It's just good for flex thats all.Last edited by Geoff; 08-15-2014 at 09:51 PM.
-
08-17-2014, 01:07 PM #26
whatever works :-)
Hinged one piece boxes with ninja flex at the hinge would be great, and useful :-)
-
08-27-2014, 08:44 PM #27
- Join Date
- Aug 2014
- Posts
- 9
Hi,
Did you ever finish the older version of the extruder?
Lenore
-
09-23-2014, 04:01 AM #28
- Join Date
- Sep 2014
- Posts
- 1
My flexible (premium sebs filament from ebay.com.au) arrived today and no luck printing it on my falshforge dual. however after many googling if came to this post and found out the spring load feeder is the problem. i tried to hold down the spring tab with my hand when feeding it fed nicely! i end up putting a piece of plastic into the gap above the spring tab then all problem solved! thank heaps Geoff!
-
09-23-2014, 05:45 AM #29
Hmm, wonder of that'd work for ninjaflex. I feel an experiment coming on :-)
-
09-29-2014, 09:51 AM #30
- Join Date
- Sep 2014
- Location
- Orlando, Florida
- Posts
- 1
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery