Results 1 to 10 of 13
Threaded View
-
09-25-2014, 10:35 AM #6
Interesting. I was under the impression that the EEPROM has a more limited number of writes/rewrites then typical memory and that it should only be used when necessary for permanent value changes, but I could be totally wrong! I don't even know if the RAMPS has another type of memory.
So could one bake the G28 and G29 into the start up GCode after the bed has reached its desired temp?
I'm guessing this is a non-issue but does the probe switch ever show signs of melting with the heat from the bed?
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion