Close



Results 1 to 4 of 4
  1. #1

    filament coming out squiggly

    Hi, I'm still fine tuning my printer trying to get consistent prints. I'm having an issue where my filament is coming out of my 1.75 hexagon hot end squiggly like in the attached photo... What can I do to fix this? Thanks!
    Attached Images Attached Images

  2. #2
    Super Moderator DrLuigi's Avatar
    Join Date
    Oct 2013
    Location
    Belgium
    Posts
    502
    I've had something equal, if i remember it right, your bed isnt level/Z isnt set correctly, when done correctly it will go away

  3. #3
    Engineer
    Join Date
    Jul 2014
    Location
    Eastern Colorado
    Posts
    536
    Move the nozzle closer to the bed.

  4. #4
    Staff Engineer printbus's Avatar
    Join Date
    May 2014
    Location
    Highlands Ranch, Colorado USA
    Posts
    1,436
    Add printbus on Thingiverse
    If you haven't checked it, make sure you have clearance between the large extruder gear and the bolts for the upper wheels on the X-carriage.
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •