Results 1 to 10 of 10
Threaded View
-
11-25-2013, 06:59 PM #6
Thanks Nicholas. RepRap wiki says the Morgan is going to be the default: http://reprap.org/wiki/RepRap_Morgan . RepRap Wally seems to cost much for PLA: "Printing Wally is no small task. The printed parts take almost 1kg of PLA and 40-45 hours to print a complete set. Nicholas Seward recommends PLA printed at a 0.3mm layer height and 15% infill with 3 perimeters." (http://reprap.org/wiki/Wally) . I think Wally won't be the default RepRap until it takes less PLA.
Last edited by RepRapVN; 11-25-2013 at 07:01 PM.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion