Results 1 to 7 of 7
Thread: .40mm hexagon speed?
Threaded View
-
09-05-2014, 09:45 PM #5
Setting the print speed is done in the slicer program. If you're using slic3r, first enable expert settings mode under File | Preferences. Restart slic3r. Now on the Print Settings tab you should see a speed label on the left. Click on it.
If you think you're having print issues, I'd start a new thread with some pictures showing what you have for printing results. Note that layers are going to be noticeable.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion