Results 1 to 10 of 73
Threaded View
-
08-20-2014, 12:43 PM #10
Hi all! New member to this forum, however I am on the reprap forum also. I ordered the 10" I3V last night. So stoked!!!! I am going to order an E3dv6 tonight. Need to order a power supply. I have been looking at the LED ones, but am concerned about the noise. This is going to be in an inside room, so will need to dampen as much noise as possible. Any recomendations?
ToddLast edited by usarmyaircav; 08-20-2014 at 01:20 PM. Reason: Corrected typo not LCD, but LED. doh!
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion