Results 1 to 10 of 14
Thread: What type of infill do you use?
Threaded View
-
08-14-2014, 09:08 AM #8
I'm in advanced settings all the time. Maybe my installation went wrong, but my first-time use of Cura was v14.07 and there's no option anywhere to set the infill type. Not on the Basic, advanced, or the expert settings.
EDIT: I also don't see selection of infill type mentioned in the on-line manual for Cura, current as of v13.11.2
EDIT #2: Today I found discussion in the user forum at Ultimaker that the ability to select infill type was removed from Cura at or around v13.04. That would explain the disconnect.Last edited by printbus; 08-14-2014 at 12:58 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion