Results 1 to 10 of 26
Thread: Nylon Filament
Threaded View
-
08-06-2014, 11:41 AM #19
Oh, misunderstood. Here are a few photos. The white stuff you see is Sugru. I used it to keep the wires from flexing and breaking off. Nothing worse than losing power on that servo and getting a head crash. It's not pretty but it works well. The piece of copper wire you see sticking out helps torque the sensor over so it's more parallel with the bed. The side of my hotend carriage is a bit angled and I needed to compensate for that. I know it looks jury rigged, but, it works well.
AL01.jpg AL02.jpg AL03.jpg AL04.jpg AL05.jpgBambu P1S/AMS
NVision4D http://nvision4d.com
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion