Results 1 to 5 of 5
Threaded View
-
08-05-2014, 05:20 AM #5
- Join Date
- Jul 2014
- Location
- EU
- Posts
- 26
Check alignment of belts and pulleys. From my experience, they tend to get misaligned with use, if you see torn rubber from belt on the pulleys, there's a chance that they are the source of the noise.
The whole case works like a violin or a guitar because of plywood, it resonates so much I found it impossible to determine the source of all the noises with my ears only :/ Tuning the pulleys did help though.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help