Results 1 to 10 of 38
Thread: Problems with filament jambs
Threaded View
-
07-28-2014, 01:13 PM #11
I have had this happen due to the twist getting more and more pronounced. All of a sudden, the spool will just spin and let a loop out to relieve the tension. I have seen this happen! The good news is if you take the spool off of the dowel, you can untwist it some amount and the filament will go back onto it nicely.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion