View Poll Results: What's your preferred Heatbed Surface?
- Voters
- 12. You may not vote on this poll
-
Kapton Tape, single / double sided
1 8.33% -
Blue painters Tape
6 50.00% -
Glass
1 8.33% -
Aluminum Bare
0 0% -
Glass with ABS slurry/ hairspray
3 25.00% -
Aluminum with kapton ABS slurry/ hairspray
1 8.33%
Results 1 to 10 of 16
Thread: Blue Tape vs Kapton
Threaded View
-
07-22-2014, 02:13 AM #14
I get great results with Aquanet Unscented "Super Extra Hold" that I get at Target. When I first built my printer I did a lot of reading about adhesion and a lot of guys were recommending Aquanet. However, I pretty much use Elmer's Purple Glue Stick for ABS these days. Both work well though on glass at 110C. And, both wash right away in the sink.
Bambu P1S/AMS
NVision4D http://nvision4d.com
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion