Results 1 to 8 of 8
Thread: PET+ Filament
-
07-18-2014, 04:01 PM #1
PET+ Filament
Has anyone tried PET+ filament? I ordered a 1 lb spool from MadeSolid...seemed interesting to try.
http://madesolid.com/pet+.html
-
07-18-2014, 07:17 PM #2
- Join Date
- Oct 2013
- Location
- new jersey
- Posts
- 752
I have used alot of it. Been using it for about 6mos now. One of my prints is on their homepage. What do you want to know?
-
07-20-2014, 12:06 PM #3
-
07-20-2014, 05:36 PM #4
- Join Date
- Oct 2013
- Location
- new jersey
- Posts
- 752
for the translucent ones i print at 245. opaques i will do at 255.
-
07-20-2014, 07:26 PM #5
what feed and transit speed do you generally run for say a .1 or .2 resolution?
-
07-20-2014, 08:14 PM #6
- Join Date
- Oct 2013
- Location
- new jersey
- Posts
- 752
around 4000mm/min print speed.
-
07-21-2014, 10:02 PM #7
Thanks for the info, it printed great. However, it's a little messier than I thought.
-
07-21-2014, 11:05 PM #8
- Join Date
- Oct 2013
- Location
- new jersey
- Posts
- 752
yes until you get everything good and tuned, it will be a little messy. it likes to catch on the nozzle and collect but it really only does this if something isnt quite right. depending on you hot end it can need alot of retraction and other ooze control settings. with everything tuned and it printing correctly it will print as clean as pla.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion