Results 1 to 10 of 22
Thread: Printing Convex Overhangs
Threaded View
-
07-16-2014, 07:07 AM #6
To be honest I've never tried printing these features without support. I think its about time I print a few tests without support to dial in the optimal settings. I think a sphere is probably the worst case scenario so it'll be a good model to test with.
Thanks for the pics RobH2. After your second test finishes, if you could post what speed/ temp you're using, it would be much appreciated.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion