Results 1 to 2 of 2
-
07-03-2014, 08:49 AM #1
- Join Date
- Feb 2014
- Posts
- 18
Makerfarm i3v heat bed not heating up
Woke up this morning to a finished print, came out great. I went to start the second part and the bed wont heat up. I just got done changing the wires twice and the thermistor is functioning, goes up when I put my finger on it
Could something be fried on my ramps? I have an extra so that's probably my next step.
thanks in advance.
-
07-04-2014, 12:09 PM #2
- Join Date
- Feb 2014
- Posts
- 18
turned out to be the spot for power on the ramps board melted.. luckily I had another fried ramps so I did a swap and all is well.. Made a mount for a 60mm fan to cool it off and turned my voltage down on my power supply a little.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help