Results 1 to 4 of 4
Thread: Fualty sensor?
-
07-02-2014, 10:47 AM #1
- Join Date
- May 2014
- Location
- In a galaxy far far away.
- Posts
- 2
Fualty sensor?
Printer: Printrbot Metal Simple. Using Repetier v 0.56
I think my sensor may be fualty/broken. When I try to home the Z axis, it doesn't home, it just goes up a little bit.
Do you know if the sensor is broken or if it may be a firmware problem?
-
07-02-2014, 05:37 PM #2
- Join Date
- Jan 2014
- Posts
- 462
Your end stop may be disconnected or borked. Send M119 to the printer and see what you get back - it will tell you if the Z end stop is triggered.
-
07-02-2014, 05:42 PM #3
- Join Date
- May 2014
- Location
- In a galaxy far far away.
- Posts
- 2
Ok. I will send that command and see what I get before getting a new part.
-
07-02-2014, 06:04 PM #4
And you can manually trigger your end-stops with your fingers to verify the status changes when ask the firmware to return their status.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion