Results 1 to 10 of 27
Thread: What did I do wrong?
Threaded View
-
06-28-2014, 10:50 PM #15
OK NOw I am really confused. Took a couple minute break, and came back and rehit the Home thig and it seemed good. I have it printing the two top files and when the string of gooey comes out the end instead of a nice steady string that is smooth on the bed it is sqiggly. I look at it close with an LED Flashlight and it is off the bed too high still but instead of it being a mile away it looks like it is about the thickness of the string too hight. I set the depth using a piece of paper with a slight drag when it was cool, and used a set of calipers in four corners of the glass to the x axis cross bars. It is as level as it can get (Or atleast as level as I could get it) Wish there was a way to adjust it without it changing so drastic. Any upgrade or anything I can do to get the bed up or the head down like just a tiny big? Any tricks?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion