Results 1 to 10 of 14
Threaded View
-
05-12-2024, 01:30 AM #6
- Join Date
- May 2020
- Posts
- 636
Sounds very much like the nozzle is slightly too far from the bed.
Suggest.....Print a 50mm square just one layer thick and adjust the 'Z' offset in the slicer plus or minus 0.01mm, whichever brings the nozzle closer to the bed.
Remove print and see if each extruded line is stuck to the adjacent one, if not, then print again but alter the 'Z' offset by another 0.01mm or 0.02mm to lower the nozzle until all lines are stuck together.
If you start getting a rough sea effect the nozzle is too close.
230 nozzle temp seems a bit low. Perhaps increase the nozzle temp to mid way between recommended temps for your PETG.Last edited by Bikeracer2020; 05-12-2024 at 02:16 AM.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help