Results 1 to 6 of 6
Thread: PEI build plates
Threaded View
-
04-14-2024, 01:46 AM #4
- Join Date
- May 2020
- Posts
- 626
Did You adjust the 'Z' offset in the slicer or just the 'Z' height when setting the initial nozzle difference?
I should have made that clearer in my answer , now rectified.
From your description it sounds as if your nozzle was slightly too far away using the PEI sheet.Last edited by Bikeracer2020; 04-14-2024 at 01:51 AM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion