Results 1 to 2 of 2
Threaded View
-
03-03-2024, 02:14 AM #2
- Join Date
- May 2020
- Posts
- 626
Could be the nozzle is too close to the bed.....perhaps adjust the "z" offset in +0.02 increments.
Print a bed leveling test to check.
Clean extruder filament gear teeth for ground filament.
Perhaps fit a new nozzle.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)