Results 1 to 3 of 3
Thread: Strange layer problems
Threaded View
-
02-04-2024, 02:11 AM #2
- Join Date
- May 2020
- Posts
- 627
Just my opinion.......
I think the nozzle is too close to the bed, try increasing the 'Z' offset in +0.02mm increments and print one of the many bed leveling STL files on such as Prusa Printables.
Always a good idea to calibrate the 'e' steps for the extruder.
Loads of videos on Youtube about bed leveling and calibrating.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion