Results 1 to 3 of 3
Thread: Sloopy Prints.
-
09-10-2023, 03:51 PM #1
- Join Date
- Sep 2023
- Posts
- 2
Sloopy Prints.
Howdy all, I have a ANYCUBIC Mega X. Prints weren't sticking so I got a new glass bed. Nozzle was underextruding (probably) so I replaced the nozzle. I am getting really sloppy prints, albeit better then they were, but can't i do better with slicer settings (Cura)? I am using PLA, nozzle width=0.4mm. I have varied temperature, layer height, speed, but I don't seem to be getting nice prints. I have enclosed a picture. the part is about 32 mm.
-
12-31-2023, 07:02 PM #2
- Join Date
- Dec 2023
- Posts
- 4
Have you run the calibration in Cura around the flow rate? Possibly might be too much filament coming out at once, or the print is too slow?
-
01-01-2024, 10:52 AM #3
- Join Date
- Sep 2023
- Posts
- 2
Thank you. I am not familiar with the calibration function in Cura. i will take a look for it.
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help