Results 1 to 4 of 4
Threaded View
-
10-24-2023, 07:39 PM #3
- Join Date
- Oct 2023
- Posts
- 4
it wont let me edit my last post ya know I do not think i added the printhead settings maybe this is it not sure what the equivalent of those are
edit well I didn't find those but I did set the z offset up by a full mm just to be sure it didn't touch the bed to see if it would try to move at all and no it did not it will only extrude after it goes though its calibration movements and then lowers itself to the corner of the bedLast edited by don't; 10-24-2023 at 07:59 PM.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help