Creator Pro 2 Runs Wild

[FlashForward]

Can anyone explain what can be seen in the attached video? When I print the g-code for a single device, it prints fine - right or left. When I print the g-code for a duplicated device, my lefter extruder sits offline and the right extruder, after a couple of seconds, locks into a Y-Axis back-and-forth rampage. I tried power cycling the printer and recreating the g-code in Flashprint but to no avail. Do I need a new motherboard or is there a reset that I do not know about.https://www.youtube.com/shorts/tqgYrT-qGjc

[Bikeracer2020]

Is your printer still under warranty ?
If so, send video and query to retailer for an explanation and hopefully a solution.

[B3d_ArmoredWarefare]

CP2 doesn't like the newest version of flashprint. I had to revert back to 5.3.4