Results 1 to 2 of 2
Threaded View
-
05-22-2023, 07:00 AM #2
- Join Date
- Nov 2022
- Posts
- 18
Did you ever get this fixed?
I see over 1100 reads, but no replies.
A little more info would help like what material, temp, and slicer used (and did you check and see if supports are required).
You can rule out a mechanical issue by printing something simple like a cube stretched in the z axis a little taller than where your print is messing up.
If that prints ok, then you can most likely rule out any mechanical issues, and look into slicer settings.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion