Results 1 to 2 of 2
Thread: Ender 3 S1 Plus TPU Help
-
05-06-2023, 09:12 PM #1
- Join Date
- May 2023
- Posts
- 2
Ender 3 S1 Plus TPU Help
Hello everyone, I am a complete noob to 3D printing. Just got this machine and have successfully printed out quite a few parts for a RC airplane out of PLA. BUT, I tried today printing TPU for the wheels on the airplane, and am having an extremely difficult time. TPU is dry, just opened it out of the box and put it straight on for the print, settings for the print were as follows: 230 print temp, 40 degree bed temp, no part cooling, and no retraction. The first few failed prints I was getting a little coming out of the nozzle but it would just blob up on the nozzle instead of sticking to the bed, and now I can't get anything to even come out. Not sure where to go from here? Help please!
-
05-06-2023, 10:16 PM #2
- Join Date
- May 2018
- Posts
- 566
nozzle needs to be a larger diameter for TPU .5 or .75.. larger the better.. stuff is very hard to print.
Good luck!
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion