Y Belt Rubbing Solutions

[Roxy]

Hello MarkerFarmers!

...

One thing I was thinking of trying is to add wedge shaped washers that I would print out and press fit over the bearings to force the belt away from the wall.

Have any of you guys been able to solve this problem?

Enjoy as I attempt to draw my idea in ASCII for great justice! :P

|==|\++/|==|
|==|/++\|==|

I slotted the bearing mount hole and added some eye bolts to adjust tension and alignment.

So you've tried adjusting the tightness of the bolts holding the pulley clamps to the front plate? Adjusting the angle of the bolt with respect to the belt should affect where the belt rides. My pulley clamps were glued in place prior to assembly, so all I could do was use
...

So I don't have a MakeFarm printer.... But it is RepRap. Can't you just print yourself an updated part and make the problem go away?