Results 1 to 3 of 3
Threaded View
-
07-21-2022, 05:22 PM #3
- Join Date
- Feb 2017
- Posts
- 79
I will give it a go, I've always been able to print at this speed/temp before w/o the issue. This spool of filament is about done but I'm curious if anything in these images tell people right away of any particular issue. I generally print at .28mm but I doubt .02mm would make any difference. I can't tell if this is undere xtrusion, combined with a bit of ringing or what. It's not consistent through entire side, layer, etc.
Thanks
Dave
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help