Results 1 to 10 of 13
Thread: Print perforation
Threaded View
-
06-14-2022, 08:40 AM #8
- Join Date
- Jun 2014
- Posts
- 886
This was more a representative sample than a final model, as until now there were no specifications. Does the model resemble your objective, if one ignores the dimensional aspects? That is, the top of the cylinder is a larger diameter and has no holes, as they would puncture the sides. Should the entire top have holes and allow the sides to be punctured?
Would you care to provide height, bottom and top diameters? Radial arrays are more difficult (for me) to accomplish, while rectangular arrays will have elements that subtract from the surface, again a limitation of my skill set.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help