Results 1 to 1 of 1
-
10-26-2021, 02:24 AM #1
- Join Date
- May 2019
- Location
- Norway
- Posts
- 1
Makerbot Method X, bad floor / bulging
Hello,
I have been having problems printing ASA/ABS/PLA, its the same for all prints and i can not figure out why.
I have calibrated the extruder, use the default print settings and print with a raft. I use new ASA and SR30. I have tried different extruders and i calibrate the buildplate whenever i change.
The first couple of layers and the bottom always seems to be bad, but the rest of it is very nice and as i expect. But i can not use it because om the floor and the first couple of layers.
I have tried different settings and so, but i have not found anything that works.
See the pictures.
Any help would be much appreciated.
Cura slicer issue
09-13-2024, 02:44 AM in 3D Printing Slicer Discussion