Auto_Bed_Leveling with positive Z_PROBE_OFFSET_FROM_EXTRUDER

[Roxy]

Wow! Thanks for all of that, you have been busy. I will give it all a try this morning.
I have been busy too and have made a build page of one of these little machines that this code will be working on.
http://regpye.com.au/SmartRap%20builds.html

Wow! That is a clean design!

Back to the double raising of the Z-Axis. If you agree it is doing that... Probably we should make the

#define Z_RAISE_BETWEEN_PROBINGS 2

The reason is... You only deflect less than 1mm to activate the Z-Probe. Going up a whole bunch is making the double raising too much now that the code (very likely) is getting the nozzle off of the bed after a measurment. But I don't have a machine to test on.