Results 1 to 10 of 10
Thread: Layer Failure
Threaded View
-
05-05-2021, 10:07 AM #10
- Join Date
- Aug 2020
- Location
- United Kingdom
- Posts
- 249
I have been printing both PA and Pet-G on the ender! but the result with PET was disappointing due to stringing. I have printed a lot of semi pressure ( 6 Bar test) bottle tops with spectrum nylon PA6 but in an enclosure.
I am Using the Ultimaker Cura slicer with no problems.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion