Results 1 to 6 of 6
Threaded View
-
12-14-2020, 08:43 AM #4
- Join Date
- Dec 2020
- Posts
- 2
I've documented my assembly process in my blog. https://blog.cyril.by/en/3d-printers/sapphireplus-assembling-tips
For the filament run-out detector, you'll need to print a piece in plastic that'll be mounted in one of the column so it's not hanging on the filament itself (which, as you've noticed, will likely cause issues when unwiding the filament). I had a lot of issues about this detector, mine wasn't wired correctly. Feel free to comment on my post, so I can include your experience on my page, it might help others. Thanks!
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion