Results 1 to 10 of 757
Threaded View
-
05-07-2014, 05:30 AM #7
- Join Date
- Apr 2014
- Location
- Netherlands
- Posts
- 76
Hi Roxy, would it be possible to do something like they do with the Marlin firmware?
With normal PLA I have no problems but I can't get Lay-wood to stick on my mirror build plate so I'm using a acrylic plate on top of it which seems to stick much better.
However this plate has a few bumps and cracks but nothing worth compensating for. But after doing the G29 I get a very messy first layer because of the uneven spots.
I would like the auto calibration to only pick 3 points (delta printer) and only compensate for that, do you think this is possible with Marlin?Last edited by Egon van Engelen; 05-07-2014 at 02:52 PM.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion