Results 1 to 10 of 13
Thread: Which control board?
Threaded View
-
11-04-2020, 02:01 PM #8
wow that extruder is not cheap - but looks like a decent bit of kit. Did you get an actual microswiss or a clone ?
And the duet was definitely massive overkill.
Again: original or clone ?
I am curious why you bought a cheap printer and then more than doubled the cost with add ons - rather than just buy a better printer that didn't need anything added to it ?
Lots of people do this - and I've never really understood why.
It's a bit like amateurs who overclock computer chips. They spend a couple hundred quid on a water cooling system and then over clock the processors - when the money they spent on the cooling could have been used to juist buy much faster kit that would make a faster system without any overclocking.
To me it makes very little sense.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help