Results 1 to 2 of 2
Thread: Good adhesion except one corner
-
10-02-2020, 08:04 PM #1
- Join Date
- Aug 2020
- Posts
- 3
Good adhesion except one corner
Hello
I have an Ender 3 Pro and i recently managed to ram my hotend into the printbed while trying to calibrate my bltouch z offset.
since then in the lower left corner nothing wants to stick to the bed anymore.
I have also switched around the buildplate but its still the same problem
P_20201002_210708.jpg
P_20201001_212247.jpg
-
10-04-2020, 10:31 AM #2
- Join Date
- Sep 2020
- Posts
- 4
You are still printing too high, so further adjustment of Z offset is needed. Graphic for reference:
first_layer-768x433.jpg
If you still have curling in the corner, after perfecting first layer, then collision might have done some damage - could be either BLTouch or mechanics of the printer (axis alignment, X/Y carriage, bed surface, etc)
Then i would have few additional questions:
Can you do probe repeatability test?
Do you have enabled ABL? Did specified compensation (settings or gcode)?
Is extruder carriage (x axis) perpendicular to bed (y axis)?
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery