Results 1 to 8 of 8
Threaded View
-
06-11-2020, 06:51 AM #2
no downside going bigger - it does depend on the actual design of your printer.
If you're going for an i3 design then bigger heavier bed = more powerful motors.
Direct drive = heavier extruder and hotend setup - so bigger motors would help there.
Not sure there's any real benefit with a lightweight bowden based extruder - though again depends on what you are doing with the print bed.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help