Results 1 to 10 of 89
Threaded View
-
04-29-2014, 10:20 AM #15
OK... Well, that was intentional... I would wait until everything else checks out, but you can change that equate from 10mm to 1mm or 2mm when you are ready.
And I would leave them in for now, but eventually you will want to delete that extra chit-chat about where the code is executing and what it is doing. That just clutters up the display. That was in there just to help with debugging if the firmware went crazy.
If you got all the way through the G29 probes without an issue, we might be close. I just noticed, you have a 2.5 mm slope to your bed???? I'm guessing that is on purpose?
I'm sorry I was so tired last night. I couldn't stand to sit at my computer and try to get everything accurately typed in. This working back and forth across the globe really slows things down!
It may be we can handle the Z-Probe triggering during a print with just a few changes to the configuration.h file. I don't know about that yet. I guess the right thing to do is just wait until you print a part and see what happens ????
And once all that is taken care of... It would be good for you to visit this thread:
http://3dprintboard.com/showthread.p...2518#post12518
And add the M48 command to your Marlin_Main.CPP file. With that you will be able to measure the repeatability of your Z-Probe to know if the mechanics are working well. Probably you are going to get the best numbers we have seen so far.Last edited by Roxy; 04-29-2014 at 10:37 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help