Results 1 to 2 of 2
Thread: Extruder flow.
-
01-30-2020, 08:41 AM #1
- Join Date
- Jan 2020
- Posts
- 1
Extruder flow.
Hi, I've changed extruder on the ender 3 pro and mounted a Redrex, all ok besides the Wisamic 4mm glass plate. Re-calibrating.
In simplify 3d set nozzle diameter 0.4 multiplier to 1 and extruder size equal to the nozzle.
Result, walls from 0.23 to 0.25. Average 0.23. I do (0.4/0.23)x 1 and I get 1.73.
I change the multiplier and enter 1.73. Reprint.The walls are still 0.23 to 0.24.
Panic...
Thank you
chip
-
01-31-2020, 01:45 PM #2
- Join Date
- Aug 2015
- Posts
- 256
That's off by a lot, perhaps you're nozzle is clogged or not actually .4mm. Try a different nozzle if you have one.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion