Results 1 to 9 of 9
Thread: Help please with 1.1.9
Threaded View
-
01-18-2020, 12:35 PM #7
- Join Date
- Dec 2019
- Posts
- 10
This morning I reverted back to Marlin 1.1.9, left all the settings the same though. I think I figured out the + - issue with the firmware. I watched a video on youtube and If I understand correctly it is backwards because the probe is higher than the extruder. I still have no explanation as to why the printer is starting the prints with the z axis at .3 though. I went ahead and let it print a test piece. Other than the fact that the bottom layer looks like crap and is raised because the z starts at .3, the printer actually doesn’t print bad. I don’t think its a motor slipping, I mean it starts at .3 consistently every time. I’m about ready to just scrap it.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help