Saving G29 Bed Level Correction Matrix to EEPROM

[adamfilip]

So far im loving the mesh levelling. I actually removed the servo and probe from my printer as I dont need it anymore. the mesh takes 5 minutes to calibrate but once saved to EEProm works really well. only time i need to make a change is if i change something related to the height of the hotend or bed. I do wish the Auto mesh creation was ready. then I would keep the servo and probe. but the mesh is still more consistant then regular Auto Bed levelling.

[3DWork]

Thanks a lot for this very interesting information, will try to modify in my Marlin and test it.



---------------------------------
Best regards!
https://3dwork.io